Web FastQuote – Syncronize with FastSealCreator

Before machined seals can be properly quoted, the online store must receive information from the software. This information is sent and stored online. Only if changes are made on the software that affects the pricing, this information is needed to be resent. The following instructions are synchronize the pricing settings from the FastSealCreator into the …

Web FastQuote – What is it?

What is a Web FastQuote store? In resume, the store created by the FastSealCreator software, described here, will allow any company that uses the FastSealCreator software to: This enables one of the two possibilities for a FastSealCreator user: How does it works for the FastSealCreator user? For the FastSealCreator user, that will be the owner …

Web FastQuote – store creation

When pressing the WebFastQuote on the left menu, the following screen will be presented when the user store does not exist. It is highly recommend that “what is a Web FastQuote store” documentation is read before proceeding. This instructions are to be followed to create a new online store When a store was not yet …

Tool management – Material parameters

A correct definition on the material parameters will ensure that the tool is correctly used during machining. Each group settings can be different from the example on this web page as there are settings that are only available for a determined tool group. For example, a drill does not need different settings for finish or …

Report issue

When a problem is found, it can be reported. Creating a report will ensure our development team receives all the needed information to replicate a issue and to correct it if needed. The report issue button is located on the lower right side of all profiles: After pressing the report issue button, the following window …

Tool management – Cutting limits

A correct definition on the cutting limits will ensure that the tool is correctly selected by the software and that the physical limits of the tools are respected avoiding errors or crashed on the g code. Each group of tools has a different set of settings. Explore the groups below for examples and detailed information …

Multiple parts with chamfers (BUS07)

Version 5.4.2.1 introduces the possibility of machining several parts after a single outside and inside machining. This feature was available in BUS03 profile, but now BUS07 introduces the same concept with the ability of machining also chamfers. Chamfers can be defined in size and length. As example of the part on the image on the …

GR03R 60x80x30 – FANUC 0i-TF

In this post all steps are shown until reaching the GCode for a Utec PLM250E – a 8 tool slot machine, where the software output is very similar to the original equipment manufacturer. A simple GR 50x60x10 profile was selected. Nominals Variables Diameter view Cross section view Material selection PTFE Bronze 55×75 was selected GCode …

FPES16 60x70x9 – Sinumerik 810

In this post all steps are shown until reaching the GCode for the a sinumerik 810 control with linear tools A FPES16 60x70x9 was selected. Nominals Variables Diameter view Cross section view Material selection PTFE Bronze 55×75 was selected GCode The code can be totally seen below that corresponds to the settings chosen. The M-codes, …

Tool management – Definitions

Each cutting tip can have different settings that defines how the tool is used by the software. The user can add, edit, clone and delete tools to suit their exact tool system. Basic settings The basic settings of each tool are defined as follows: Description A small text to help to identify the tool. It …