Important: For chevron tools this restriction must be set after version 5.5.6.1 on the tool management. The most typical value is 45 for 45ยบ tools. See more information below for specific scenarios. General information Some tool groups can have angle restrictions, and when available they will be listed on the Advanced Settings, as shown below: …
Tag archives: restriction
Maximum cross section – restriction
This restriction added in version 5.4.6.2 (September 2024) allows the operator to discard a tool based on the cross section size of the material. This restriction is particularly useful on machines with linear tool posts where tools are placed closely to each other, and where the cross section of the material, if larger than a …
Maximum inside dimension – restriction
The engine to select tools is quite complex and provides a unpaired flexibility. The restrictions are Boolean conditions that are verified. If accepted (true), the tool passes that restriction and can be considered a candidate to a determined operation. This restriction verifies if the machining diameter matches the value set by the customer. If it …